Bottle handling conveyor solutions
Review route, stability, guides, accumulation and machine-interface requirements for bottles and jars.
Open bottle handling guidance →First-party conveyor footage
Bottle Handling Conveyor Video: Stability & Guide Checks
Use the footage to discuss bottle support, guide contact and spacing, then confirm suitability with representative products and the real line conditions.
Supportbase contact and transfer condition
Guidesclearance, contact and adjustment
Trialnormal flow, stop, restart and queue
Movement reference
Watch the bottle-handling conveyor footage.
This 17-second Lancing video shows clear bottles travelling on a flat powered conveyor while green side guides keep the containers within the handling lane. It is useful for discussing product support, guide position and spacing, but it does not by itself confirm suitability for a different bottle, fill condition, speed, transfer or production environment.
Evidence boundaries
Separate what is visible from what still needs to be tested.
Video is useful evidence only when the viewer knows the product, operating state and test conditions. Use it to identify questions, then record the measurements and trial results needed for the actual conveyor specification.
| Question | What this footage can show | What still needs project evidence |
|---|---|---|
| Is the product supported? | The visible bottles remain upright on a continuous flat surface. | Base dimensions, mass, centre of gravity, underside condition and behaviour at every transfer. |
| Do the side guides control the route? | The green guides define the visible lane and limit lateral movement. | Guide opening, contact pressure, adjustment range, changeover repeatability and scuffing risk. |
| Is the spacing suitable? | Individual containers can be seen with gaps during the recorded sequence. | Required product pitch, line speed, sensor response, accumulation condition and downstream demand. |
| Will the line recover from a stop? | The clip provides a normal movement reference. | Controlled stop, loaded restart, queued release, fault recovery and any pressure between products. |
| Is the design suitable for the environment? | The visible route can be reviewed for general access and guide position. | Cleaning method, contamination risk, guarding, isolation, materials and site-specific risk assessment. |
Representative trial
Test the least favourable product and operating state.
- Choose the samplesInclude the smallest, largest, lightest, heaviest or least stable variants that could control the design. Where empty and filled containers behave differently, include both states.
- Define the routeRecord straight lengths, curves, inclines, transfer heights, adjacent machines and the guide opening required for each format.
- Run the operating statesObserve normal flow, controlled stop, loaded restart, downstream blockage and the expected queue or accumulation condition.
- Record the resultKeep the product identity, measured settings, video angle, result and any adjustment together so the evidence can be repeated.
Related technical guidance
Continue from the movement reference to the full specification.
Conveyor transfer layout details
Define plan and elevation interfaces, product support, transfer gaps, speeds and acceptance checks.
Open transfer guidance →Product samples for conveyor testing
Choose representative samples and record the operating conditions needed for a useful trial.
Open sample guidance →Bottle handling review
Use your own products to confirm the conveyor requirement.
Send the bottle range, route, output and connected-machine details so Lancing can identify the measurements and representative checks needed before quotation.